User Manual

------------------------------------------------------------------------------------------------------------------------------------------
--------

(+I[H3GQKX:5?*/?HGYOIYKZ[VGTJOTYZGRRGZOUT


FDM 3D Printer 
Toolhead type
> Print Form SD
Filament
Utility
Tip:

scald.

the last step before shut down and reboot for switching successfully.

then pull out the filament tube, otherwise it is difficult to pull out the filament
tube.
,*3*[GR*VXOTZ
--------------------------------------------------------------------------------------------------------------------------------------------




 

ʒ

tube into the right side filament tube joint
 
ʓ







