User's Manual
Table Of Contents
- USR-G786-G User Manual
- 1.Introduction
- 2.Get Started
- 3.Utility Configuration
- 4.Serial Port
- 5.Selecting an Operating Mode
- 6.General Function
- 7.AT Command Set
- 7.1.AT Command Examples
- 7.2.AT Command Set
- 7.2.1.AT
- 7.2.2.AT+H
- 7.2.3.AT+Z
- 7.2.4.AT+E
- 7.2.5.AT+ENTM
- 7.2.6.AT+WKMOD
- 7.2.7.AT+CMDPW
- 7.2.8.AT+STMSG
- 7.2.9.AT+RSTIM
- 7.2.10.AT+CSQ
- 7.2.11.AT+SYSINFO
- 7.2.12.AT+UCPIN
- 7.2.13.AT+RELD
- 7.2.14.AT+CLEAR
- 7.2.15.AT+CFGTF
- 7.2.16.AT+VER
- 7.2.17.AT+SN
- 7.2.18.AT+ICCID
- 7.2.19.AT+IMEI
- 7.2.20.AT+CIP
- 7.2.21.AT+LBS
- 7.2.22.AT+CCLK
- 7.2.23.AT+PING
- 7.2.24.AT+UART
- 8.Contact Us
- 9.Disclaimer
- 10.Update History
USR-G786-G User Manual Technical Support: h.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
50
MODBUSEN
Query/set whether to enable Modbus protocol conversion
Identity package commands
REGEN
Query/set whether to enable identity package
REGTP
Query/set the content type of
identity
package
REGDT
Query/set
user-defined identity package data
REGSND
Query/set identity package sending type
Heartbeat package commands
HEARTEN
Query/set whether to enable heartbeat
HEARTDT
Query/set heartbeat package data
HEARTSND
Query/set heartbeat pack
age
sending type
HEARTTM
Query/set heartbeat pack
age
sending interval
HTTPD commands
AT+HTPTP
Query/set HTTP request type
AT+HTPURL
Query/set URL
AT+HTPSV
Query/set HTTP server address and port
AT+HTPHD
Query/set HTTP request header
AT+HTPTO
Query/set HTTP timeout
AT+HTPFLT
Query/set whether to filter HTTP header
SMS commands
DSTNUM
Query/set the target mobile phone number of SMS mode
SMSFLT
Query/set whether to enable only receive SMS from source number
CISMSSEND
Send SMS
7.2.1.AT
Function：Test commands to test whether the current device is active
Format
Query:
AT{CR}
{CR}{LF}OK{CR}{LF}
7.2.2.AT+H
Function：Helping command
Format
Query:
AT+H{CR}
{CR}{LF} help message {CR}{LF}
Parameter：
help message：command.
7.2.3.AT+Z
Function： Reload the module.