User's Manual
Table Of Contents
- USR-G786-G User Manual
- 1.Introduction
- 2.Get Started
- 3.Utility Configuration
- 4.Serial Port
- 5.Selecting an Operating Mode
- 6.General Function
- 7.AT Command Set
- 7.1.AT Command Examples
- 7.2.AT Command Set
- 7.2.1.AT
- 7.2.2.AT+H
- 7.2.3.AT+Z
- 7.2.4.AT+E
- 7.2.5.AT+ENTM
- 7.2.6.AT+WKMOD
- 7.2.7.AT+CMDPW
- 7.2.8.AT+STMSG
- 7.2.9.AT+RSTIM
- 7.2.10.AT+CSQ
- 7.2.11.AT+SYSINFO
- 7.2.12.AT+UCPIN
- 7.2.13.AT+RELD
- 7.2.14.AT+CLEAR
- 7.2.15.AT+CFGTF
- 7.2.16.AT+VER
- 7.2.17.AT+SN
- 7.2.18.AT+ICCID
- 7.2.19.AT+IMEI
- 7.2.20.AT+CIP
- 7.2.21.AT+LBS
- 7.2.22.AT+CCLK
- 7.2.23.AT+PING
- 7.2.24.AT+UART
- 8.Contact Us
- 9.Disclaimer
- 10.Update History
USR-G786-G User Manual Technical Support: h.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
39
serial ports. As follows:
(1) Set baud rate to 115200, no check bit, data bit 8, stop bit 1, open serial port, click “Load Fw”, and select
the firmware to be upgraded.
(2) Follow the prompts and wait for the device to be upgraded.