User's Manual
Table Of Contents
- USR-G786-G User Manual
- 1.Introduction
- 2.Get Started
- 3.Utility Configuration
- 4.Serial Port
- 5.Selecting an Operating Mode
- 6.General Function
- 7.AT Command Set
- 7.1.AT Command Examples
- 7.2.AT Command Set
- 7.2.1.AT
- 7.2.2.AT+H
- 7.2.3.AT+Z
- 7.2.4.AT+E
- 7.2.5.AT+ENTM
- 7.2.6.AT+WKMOD
- 7.2.7.AT+CMDPW
- 7.2.8.AT+STMSG
- 7.2.9.AT+RSTIM
- 7.2.10.AT+CSQ
- 7.2.11.AT+SYSINFO
- 7.2.12.AT+UCPIN
- 7.2.13.AT+RELD
- 7.2.14.AT+CLEAR
- 7.2.15.AT+CFGTF
- 7.2.16.AT+VER
- 7.2.17.AT+SN
- 7.2.18.AT+ICCID
- 7.2.19.AT+IMEI
- 7.2.20.AT+CIP
- 7.2.21.AT+LBS
- 7.2.22.AT+CCLK
- 7.2.23.AT+PING
- 7.2.24.AT+UART
- 8.Contact Us
- 9.Disclaimer
- 10.Update History
USR-G786-G User Manual Technical Support: h.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
37
2． Enable Socket A：
AT+SOCKAEN=ON
3． Set socket A to TCP Client：
AT+SOCKA=TCP,test.usr.cn,2317
4． Enable Modbus protocol conversion：
AT+MODBUSEN=ON
5． Restart the module：
AT+Z
3 Test
Connect the serial port of USR-G786-G to the computer via a serial to USB cable, Modbus RTU data sent by
the serial port is converted into MODBUS TCP data by G786-G and then sent to the network side. Similarly,
G786-G converts the MODBUS TCP data on the network side into MODBUS RTU data and transmits it to the
serial port.
6.5. FTP Upgrade