User's Manual
Table Of Contents
- USR-G786-G User Manual
- 1.Introduction
- 2.Get Started
- 3.Utility Configuration
- 4.Serial Port
- 5.Selecting an Operating Mode
- 6.General Function
- 7.AT Command Set
- 7.1.AT Command Examples
- 7.2.AT Command Set
- 7.2.1.AT
- 7.2.2.AT+H
- 7.2.3.AT+Z
- 7.2.4.AT+E
- 7.2.5.AT+ENTM
- 7.2.6.AT+WKMOD
- 7.2.7.AT+CMDPW
- 7.2.8.AT+STMSG
- 7.2.9.AT+RSTIM
- 7.2.10.AT+CSQ
- 7.2.11.AT+SYSINFO
- 7.2.12.AT+UCPIN
- 7.2.13.AT+RELD
- 7.2.14.AT+CLEAR
- 7.2.15.AT+CFGTF
- 7.2.16.AT+VER
- 7.2.17.AT+SN
- 7.2.18.AT+ICCID
- 7.2.19.AT+IMEI
- 7.2.20.AT+CIP
- 7.2.21.AT+LBS
- 7.2.22.AT+CCLK
- 7.2.23.AT+PING
- 7.2.24.AT+UART
- 8.Contact Us
- 9.Disclaimer
- 10.Update History
USR-G786-G User Manual Technical Support: h.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
35
Click the query to get the converted location information
6.4. Modbus
In network transparent mode, if the terminal device transmits data through Modbus RTU protocol and the
server communicates through Modbus TCP protocol, user can enable Modbus function. After this function is
enabled, G786-G converts the Modbus TCP protocol data sent by the server into Modbus RTU data and sends
it to the terminal device, and converts the Modbus RTU protocol data sent by the terminal device into
Modbus TCP data and sends it to the server.
1 Set by software: