User's Manual
Table Of Contents
- USR-G786-G User Manual
- 1.Introduction
- 2.Get Started
- 3.Utility Configuration
- 4.Serial Port
- 5.Selecting an Operating Mode
- 6.General Function
- 7.AT Command Set
- 7.1.AT Command Examples
- 7.2.AT Command Set
- 7.2.1.AT
- 7.2.2.AT+H
- 7.2.3.AT+Z
- 7.2.4.AT+E
- 7.2.5.AT+ENTM
- 7.2.6.AT+WKMOD
- 7.2.7.AT+CMDPW
- 7.2.8.AT+STMSG
- 7.2.9.AT+RSTIM
- 7.2.10.AT+CSQ
- 7.2.11.AT+SYSINFO
- 7.2.12.AT+UCPIN
- 7.2.13.AT+RELD
- 7.2.14.AT+CLEAR
- 7.2.15.AT+CFGTF
- 7.2.16.AT+VER
- 7.2.17.AT+SN
- 7.2.18.AT+ICCID
- 7.2.19.AT+IMEI
- 7.2.20.AT+CIP
- 7.2.21.AT+LBS
- 7.2.22.AT+CCLK
- 7.2.23.AT+PING
- 7.2.24.AT+UART
- 8.Contact Us
- 9.Disclaimer
- 10.Update History
USR-G786-G User Manual Technical Support: h.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
34
6.3. Base Station Position
USR-G786-G supports LBS base station positioning function, and can obtain general location of the device
through the operator's network. Base station positioning information is obtained through AT command,
which can be used flexibly with serial AT and SMS AT command.
AT command
Command
Function
Default parameter
AT+LBS
Query station positioning information
Empty
Note: This function does not obtain positioning information directly(E.g: latitude and longitude information),
but base station location information. Users need to obtain direct positioning information through calculation
on a third-party platform. Third-party location information services are generally require charges. User can go
to the URL to convert the actual location to test:
http://www.minigps.net/cellsearch.html (This URL is for testing only and does not guarantee site stability)
Query interface is shown below: