User's Manual
Table Of Contents
- USR-G786-G User Manual
- 1.Introduction
- 2.Get Started
- 3.Utility Configuration
- 4.Serial Port
- 5.Selecting an Operating Mode
- 6.General Function
- 7.AT Command Set
- 7.1.AT Command Examples
- 7.2.AT Command Set
- 7.2.1.AT
- 7.2.2.AT+H
- 7.2.3.AT+Z
- 7.2.4.AT+E
- 7.2.5.AT+ENTM
- 7.2.6.AT+WKMOD
- 7.2.7.AT+CMDPW
- 7.2.8.AT+STMSG
- 7.2.9.AT+RSTIM
- 7.2.10.AT+CSQ
- 7.2.11.AT+SYSINFO
- 7.2.12.AT+UCPIN
- 7.2.13.AT+RELD
- 7.2.14.AT+CLEAR
- 7.2.15.AT+CFGTF
- 7.2.16.AT+VER
- 7.2.17.AT+SN
- 7.2.18.AT+ICCID
- 7.2.19.AT+IMEI
- 7.2.20.AT+CIP
- 7.2.21.AT+LBS
- 7.2.22.AT+CCLK
- 7.2.23.AT+PING
- 7.2.24.AT+UART
- 8.Contact Us
- 9.Disclaimer
- 10.Update History
USR-G786-G User Manual Technical Support: h.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
31
2 Set by AT command:
Command
Function
Default
AT+REGEN
Query/setting enable identity package
OFF
AT+REGTP
Query/setting the type of identity package
content
USER
AT+REGDT
Query/setting user-defined information
7777772E7573722E636E
AT+REGSND
Query/setting the sending mode of identity
package
DATA
1. Enable identity package function：
AT+REGEN=ON
2. Set the type to User-defined data：
AT+REGTP=USER
3. Setup the contents：
AT+REGDT=7777772E7573722E636E
4. Setup the sending mode:
AT+REGSND=DATA
5. Reboot:
AT+Z
3 Test
Connect the serial port of USR-G786-G to the computer via a serial to USB cable, send data from serial port: