User's Manual
Table Of Contents
- USR-G786-G User Manual
- 1.Introduction
- 2.Get Started
- 3.Utility Configuration
- 4.Serial Port
- 5.Selecting an Operating Mode
- 6.General Function
- 7.AT Command Set
- 7.1.AT Command Examples
- 7.2.AT Command Set
- 7.2.1.AT
- 7.2.2.AT+H
- 7.2.3.AT+Z
- 7.2.4.AT+E
- 7.2.5.AT+ENTM
- 7.2.6.AT+WKMOD
- 7.2.7.AT+CMDPW
- 7.2.8.AT+STMSG
- 7.2.9.AT+RSTIM
- 7.2.10.AT+CSQ
- 7.2.11.AT+SYSINFO
- 7.2.12.AT+UCPIN
- 7.2.13.AT+RELD
- 7.2.14.AT+CLEAR
- 7.2.15.AT+CFGTF
- 7.2.16.AT+VER
- 7.2.17.AT+SN
- 7.2.18.AT+ICCID
- 7.2.19.AT+IMEI
- 7.2.20.AT+CIP
- 7.2.21.AT+LBS
- 7.2.22.AT+CCLK
- 7.2.23.AT+PING
- 7.2.24.AT+UART
- 8.Contact Us
- 9.Disclaimer
- 10.Update History
USR-G786-G User Manual Technical Support: h.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
24
data packet, and can achieve the data request from the serial device to the HTTP server through simple
parameter settings.
The module will filter out the received HTTP protocol header data by default, only output user data to the
serial port. Customers can choose whether to filter HTTPD header data by AT command.
1 Set parameters by software:
1. Open the setup software. Set the serial port parameters according to the serial device and click "Open PC
Serial".
2. Click "Enter Serial AT command mode" and wait for the device to enter AT command mode.
3. Click "Query all parameters" and wait for obtaining all current parameters.
4. In "Choose Work Mode" column, select "HTTPD Client Mode".
5. Set HTTPD Client mode parameters.
6. Check “More”.
7. If using an APN card, need to set the APN information.
Set APN parameter: CMNET,,,0. E.g: APN: CMNET, username:empty, password:empty, authentication method:
NONE.
8. Click "Save current parameters" to set and save all parameters.
9. Click "Restart" to restart the module.
2 Set by AT command:
1. Set the work mode to HTTPD：