User's Manual
Table Of Contents
- USR-G786-G User Manual
- 1.Introduction
- 2.Get Started
- 3.Utility Configuration
- 4.Serial Port
- 5.Selecting an Operating Mode
- 6.General Function
- 7.AT Command Set
- 7.1.AT Command Examples
- 7.2.AT Command Set
- 7.2.1.AT
- 7.2.2.AT+H
- 7.2.3.AT+Z
- 7.2.4.AT+E
- 7.2.5.AT+ENTM
- 7.2.6.AT+WKMOD
- 7.2.7.AT+CMDPW
- 7.2.8.AT+STMSG
- 7.2.9.AT+RSTIM
- 7.2.10.AT+CSQ
- 7.2.11.AT+SYSINFO
- 7.2.12.AT+UCPIN
- 7.2.13.AT+RELD
- 7.2.14.AT+CLEAR
- 7.2.15.AT+CFGTF
- 7.2.16.AT+VER
- 7.2.17.AT+SN
- 7.2.18.AT+ICCID
- 7.2.19.AT+IMEI
- 7.2.20.AT+CIP
- 7.2.21.AT+LBS
- 7.2.22.AT+CCLK
- 7.2.23.AT+PING
- 7.2.24.AT+UART
- 8.Contact Us
- 9.Disclaimer
- 10.Update History
USR-G786-G User Manual Technical Support: h.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
17
4.2.3.Network Data Output Port
We need to set the output serial port of the USR-G786-G network data. Setting commands and parameters as
follows:
Figure 3 Network data output serial port setting instructions
Command
Descriptions
AT+CMDPT=RS232
Data sent from network is output on 232 serial port.
AT+CMDPT=RS485
Data sent from network is output on 485 serial port.
AT+CMDPT=RSALL
Data sent from network is output on 232 and 485 port.
（Default）
In order to ensure the data output efficiency, please select one serial port as the network data output port
according to needs.
5. Selecting an Operating Mode
USR-G786-G has three working modes: net transparent mode, HTTPD Client mode and SMS mode.
5.1. Net Transparent Mode