User's Manual
Table Of Contents
- USR-G809 User Manual
- 1.Introduction
- 1.1.Overview
- 1.2.Features
- 1.3.Specification
- 1.4.Interface
- 1.5.Indicator
- 1.6.Dimensions
- 2.General Function
- 2.1.Web Interface
- 2.2.Hostname
- 2.3.User Password Settings
- 2.4.Reboot Timer
- 2.6.Reboot
- 2.7.Reload Button
- 3.Interface
- 3.1.WAN Interface
- 3.2.LAN Interface
- 3.3.Cellular Network Interface
- 3.4.WLAN Interface
- 3.5.VLAN
- 3.6.DIDO
- 4.Network
- 4.1.Network Switch
- 4.2.DHCP
- 4.3.Hostnames
- 4.4.Static Routes
- 4.5.Diagnostics
- 5.VPN
- 5.1.PPTP Client
- 5.2.L2TP Client
- 5.3.IPSec
- 5.4.OpenVPN
- 5.5.GRE
- 6.Firewall
- 6.1.General Settings
- 6.2.NAT
- 6.3.Traffic Rules
- 6.4.Access Restriction
- 7.Serial Port
- 7.1.Connecting Hardware
- 7.2.Serial Port Settings
- 7.3.Operation Mode
- 7.4.General Function
- Protocol description:
- 8.USR Cloud
- 8.1.Cloud Monitor
- 8.2.Add device
- 8.3.Network Status
- 8.4.Parameter Configuration
- 8.5.Firmware Upgrade
- 8.6.Records of device
- 8.7.Alarm
- 8.8.Remote Configuration
- 9.Services
- 9.1.Syslog
- 9.2.NTP
- 9.3.Email
- 9.4.SMS
- 9.5.Alert
- 9.6.Alert Examples
- 9.7.Call Reboot
- 9.8.Geolocation
- 9.9.DDNS
- 10.AT Commands Settings
USR-G809 User Manual Technical Support:
h.usriot.com
Jinan USR IOT Technology Limited www.pusr.com
90
Note:
When enable DO1 control, please do not enable DO1 in “DIDO” interface to avoid the conflict.
Please select only one event since the output is DO status.
6. Add the second alarm. Set the DO1 output level to Low, the event to WAN_4G offline. After that, click
“Save&Apply”.