User's Manual
Table Of Contents
- USR-G809 User Manual
- 1.Introduction
- 1.1.Overview
- 1.2.Features
- 1.3.Specification
- 1.4.Interface
- 1.5.Indicator
- 1.6.Dimensions
- 2.General Function
- 2.1.Web Interface
- 2.2.Hostname
- 2.3.User Password Settings
- 2.4.Reboot Timer
- 2.6.Reboot
- 2.7.Reload Button
- 3.Interface
- 3.1.WAN Interface
- 3.2.LAN Interface
- 3.3.Cellular Network Interface
- 3.4.WLAN Interface
- 3.5.VLAN
- 3.6.DIDO
- 4.Network
- 4.1.Network Switch
- 4.2.DHCP
- 4.3.Hostnames
- 4.4.Static Routes
- 4.5.Diagnostics
- 5.VPN
- 5.1.PPTP Client
- 5.2.L2TP Client
- 5.3.IPSec
- 5.4.OpenVPN
- 5.5.GRE
- 6.Firewall
- 6.1.General Settings
- 6.2.NAT
- 6.3.Traffic Rules
- 6.4.Access Restriction
- 7.Serial Port
- 7.1.Connecting Hardware
- 7.2.Serial Port Settings
- 7.3.Operation Mode
- 7.4.General Function
- Protocol description:
- 8.USR Cloud
- 8.1.Cloud Monitor
- 8.2.Add device
- 8.3.Network Status
- 8.4.Parameter Configuration
- 8.5.Firmware Upgrade
- 8.6.Records of device
- 8.7.Alarm
- 8.8.Remote Configuration
- 9.Services
- 9.1.Syslog
- 9.2.NTP
- 9.3.Email
- 9.4.SMS
- 9.5.Alert
- 9.6.Alert Examples
- 9.7.Call Reboot
- 9.8.Geolocation
- 9.9.DDNS
- 10.AT Commands Settings
USR-G809 User Manual Technical Support:
h.usriot.com
Jinan USR IOT Technology Limited www.pusr.com
29
4.2. DHCP
Static address assignment: In “Network -- DHCP”, we can assign a fixed IP address to a DHCP client device.
User can bind the MAC address with a fixed IP address, up to 20 binding rules can be added.
Note:
Hostname is empty means IP and MAC binding.
MAC is empty means hostname and IP binding.
To set all means to bind a MAC to an IP and set the hostname for this MAC.
IP address must be in the same network segment with the LAN IP address of USR-G809.
4.3. Hostnames
USR-G809 supports custom domain name resolution. Set the hostname and IP address in below interface, to
achieve the mapping between hostname and IP address.
The outside IP address can also be mapped(must be a unique public IP address). The hostname of DHCP
and static IP cannot be a number. After setting all parameters, restart the device to take the parameters
effect.