User's Manual


E‐8
SETTING THE CLOCK TIME
In order for the clock to function properly, the clock has to be set before you use it for
the first time. After powering up the unit or press and hold PRESET/TIME Button (#7)
at standby mode, the clock display will flash. To set the time, follow the steps below:
1. Tap the TUN-/HR/ / TUN+/MIN/ Buttons (#3/#4) until the correct time is
displayed..
2. Press the PRESET/TIME Button (#4) to confirm the time.
Note:
Make sure the hour is set so that AM or PM is correctly displayed. There is a PM
Indicator (#14) located in the upper left corner of the LED display. If the PM Indicator
(#14) is showing on the display, the displayed time is “PM”. If the PM Indicator (#14)
is not showing on the display, the time displayed is “AM”.
RADIO OPERATION
Press the MODE / Button (#6) repeatedly to Turn On the unit and select AM/FM
Mode, frequency will show on the LED display.
Press and hold the TUN-/HR/ Button (#3) OR TUN+/MIN/ Button (#4) to search
for the next / previous available station. If the reception is poor, try Manual Tuning to
fine-tune the station. Press the TUN-/MIN/ OR TUN+/HR/ Buttons (#6) briefly to
manually tune through the frequency band.
Adjust the VOLUME +/- Control (#9/10) to obtain the desired sound level.
The LED display will change to show the clock time after a few seconds. Press the
TUN-/HR/ OR TUN+/MIN/ Buttons (#3/4) to check the tuned frequency.
Setting the Radio Station Presets
The unit allows you to store up to 30 FM stations and 30 AM stations for easy recall
at any time.
1. Press the POWER / Button (#6) repeatedly to Turn On the unit and select
AM/FM Mode.
2. Tune to the radio station you want to store in memory.
3. Press and hold the PRESET/TIME Button (#7). The preset channel number “P01”
will be flashing on display.
4. To change the preset channel number location, press the TUN-/HR/ OR
TUN+/MIN/
Buttons (#3/4) to step through the preset locations ( P01 – P30 ).
5. To confirm the preset location, press PRESET/TIME Button (#7).
6. To store up to 30 station presets, repeat steps 2-5 above.
RECALL PRESET STATION
In AM/FM mode, press PRESET/TIME Button (#7) repeatedly to select the preset
channel.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, change the
position of the unit until the internal antenna picks up the strongest signal.
FM - If FM reception is weak, fully extend the wire antenna and vary the position and
location of the antenna until you find the strongest signal.