User's Manual


E‐10
3. Press ALARM 1 Button (#2) to confirm. The LED display will show the alarm time.
4. Press TUN-/HR/ OR TUN+/MIN/ Buttons (#3/4) to set the hour and minute
of the alarm time.
5. Press the ALARM 1 Button (#12) to confirm the alarm time. The LED display will
show the volume level.
6. Press TUN-/HR/ OR TUN+/MIN/ Buttons (#3/4) to set the volume level.
7. Press the ALARM 1 Button (#12) to confirm the volume level. The LED display
resume display the current time.
8. Alarm 2 setting procedures are same as Alarm 1.
Note : If Alarm 1 and Alarm 2 set at same time, only Alarm 2 will function.
SETTING WAKE TO ALARM OR RADIO
1. In standby mode, press the ALARM 1 Button (#2) repeatedly to set alarm 1
a. Wake to Alarm, Alarm 1 INDICATOR (wake to alam) (#15) will light up.
b. Wake to Radio, Alarm 1 INDICATOR (wake to radio) (#16) will light up.
c. Alarm 1 Off, both WAKE to ALARM & RADIO Indicators light off
2. When alarm sounds, press POWER/FUNCTION Button (#5) once to stop the
alarm and it will repeat next day same time.
3. When alarm sounding after one hour, the sound will auto off and repeat next day.
4. Alarm 2 wake to Alarm or radio setting procedures is same as Alarm 1.
STOP THE ALARM SOUND
When alarm sounds, press any buttons once to stop the alarm and it will repeat next
day same time.
SNOOZE ALARM
After the radio or alarm sounds, you may press the SNOOZE/SLEEP button (#11)
for a few more minutes sleep. The alarm will stop for approximately 9 minutes and
then turn on again.
CHECKING THE ALARM TIME
In standby mode, press and hold the ALARM 1 or ALARM 2 Button (#2/1) twice, the
alarm time shows.
AUX OPERATION
You can play other music sources (iPod, MP3 or other digital audio players) through
the speakers of the JCR-228 by connecting the AUX IN Jack (#12 ) to your external
player’s audio out jack or headphone jack.
1. Plug one end of an audio cable (not included) into the AUX IN Jack (#11) and the
other end of the cable to the headphone jack of your digital audio player.
2. Press the MODE / Button (#6) repeatedly to select the AUX mode, The LED
Display show AU.
3. Start playing the device you plugged into the AUX IN Jack (#11).
4. Slowly adjust both the volume controls of the JCR-228 and the external device
until you reach a comfortable listening level.
5. Turn off your iPod, MP3 player etc. when finish listening.
6. Press and hold the
MODE / Button (#6)
5 seconds to turn the JCR-228 off and
unplug the AUX IN Jack.