User's Manual


E‐9
BLUETOOTH OPERATION
Pairing a Bluetooth enabled device with the JCR-228.
1. Press the MODE / Button (#6) repeatedly to turn on unit and select Bluetooth
mode, “bt” will show on the LED Display. The BLUETOOTH INDICATOR (#17) will
flash.
2. Turn on the Bluetooth function for the device you want to link to, and enable the
search or scan function to find the JCR-228.
3. Select "JCR-228" from the device list when it appears on your device screen. If
required, enter the pass code “0000” to pair (link) JCR-228 with your device.
4. If you are pairing (linking) your computer to the speaker using Bluetooth, you may
need to set the JCR-228 as your computer’s default sound device.
5. After successfully pairing the JCR-228 with your Bluetooth device, The
BLUETOOTH INDICATOR (#17)) will stop flashing and remain lit.
6. If you want to pair (link) the JCR-228 with another Bluetooth device, press and
hold Pairing/
Button (#5) a few seconds. The
BLUETOOTH INDICATOR (#17)
will flash. The JCR-228 will go into Pairing/Discoverable mode. Repeat steps 2 &
3.
Now you can play music from your Bluetooth device wirelessly to the JCR-228.
1. Selecting your favorite song, press the Play
Button
on your Bluetooth device or
the Pairing/
Play/Pause/ Button (#13)
on the JCR-228 to play or pause the the
song from your Bluetooth device.
2. Press Skip Forward Button or Skip Backward Button (#6) to select the Next
or Previous track.
( The SEARCH function does not apply to Bluetooth operation )
3. Press VOLUME +/- buttons (#15) of your JCR-228 and your Bluetooth device until
you reach a comfortable listening level.
Note :
1. Refer to the manual of your cell phone, tablet PC, computer or other Bluetooth
enabled devices for Bluetooth operation since it may vary from model to model.
2. If your Bluetooth enabled device does not support A2DP profile, it will not play
the music through the speaker, even if paired (linked).
3. Remember to turn off the JCR-228 when you have finished listening, press and
hold POWER / Button (#6) a few seconds to turn off the unit.
4. Don't forget to switch off the power of your external audio device as well.
5. The music playback will automatically be paused when you have an incoming call.
When the call is ended the JCR-228 will start playing again.
ALARM OPERATION
SETTING THE ALARM TIME
You can set two different alarm times and select wake to RADIO / ALARM sound.
1. In standby mode, press and hold the ALARM 1 Button (#2) until the LED display
flash.
2. Tap the TUN-/HR/
OR TUN+/MIN/ Buttons (#3/4) to select wake to Radio
FM – Radio AM – BB (Alarm) – OFF.
(Wake to Radio FM or AM, the LED display will show the frequency. Tap the
PRESET/TIME button (#7) repeatedly to select the desired preset station.)