Apron Front Stainless Steel Sink Installation Instructions Before You Start + We recommends that all apron front sinks should be installed by an experienced, professional installer. + IMPORTANT: The enclosed cutout template will create a counter top opening with a minimal (1/8” or less) reveal. It is recommended that you discuss this with your installer and agree that this finished appearance is the desired effect. We are not responsible for improper sink or counter top installations.
Apron Front Stainless Steel Sink Installation Instructions 1. Apply painter” s tape to the cabinets for marking and footie S Fo cutting purposes. This will protect the cabinet from damage while cutting. 2. Position the template (provided with your sink) on the front of the cabinet, flush to the top and centered; secure with tape. 3. Trace the template and remove. 4, Using a sharp saw blade, carefully cut the cabinet on the traced line.
Apron Front Stainless Steel Sink Installation Instructions SUPPORT FRAMING SHOULD BE RECESSED SO THE SINK FITS FLUSH WITH THE TOP OF THE CABINET — . Cut two lengths of support framing to extend horizontally along the inside walls on each side of the cabinet. 2. Measure and mark the support mounting locations; ensure the sink rim will sit at or slightly below the top of the cabinet. 3. Position and level the supports. 4. Secure the supports with construction adhesive and screws (not provided). 5.
Apron Front Stainless Steel Sink Installation Instructions APPLY SILICONE SEALANT AFTER CLEANING THE INK EDGE AND COUNTER TOP APPLY SILICONE SEALANT WHERE THE INK MEETS THE COUNTER TOP AND CABINET. 1. Clean the bottom of the counter top and the top flange (or lip) of the sink with denatured alcohol. 2. Apply a narrow bead of silicone adhesive sealant around the side and back of the sink. 3. Carefully position and secure the sink to the counter top following the manufacturer” s instructions. 4.
