Full Product Manual

1.1 Fig.1
A: Cabinet
B: Push buttons/control lights
C: Enclosure access screws
1.2 Fig.2
D: Power cable
E: JIMCO-Special lamp
F: Lamp socket
G: Lamp clips
H: Fan
Technical Data:
UV lamp 1x8 w Operating hours 8000 timer
Voltage 120V 50/60Hz Length 310 mm
Power consumption 23 w Height 90 mm
Room area 60 m
3
Width 90mm
A: B: C:
H: F: G: E: D:
Operation
3:Timer 2:Fan 1:On/Off
High / Low
-Switch the appliance on and off with the On / Off switch
(1) The red lamp lights to indicate that the appliance is
now switched on
-The pushbutton (2) can switch between high and low
speed. The red light on the button lights when the fan is
running at high speed. The appliance always starts at
High speed when switched on.
-Pressing the Timer button (3) sets the unit to Timer
mode. When the Timer button is pressed, the fan will run
at the current speed for 8 hours, then switches speed for
16 hours. This cycle continues until the timer button (3) is
pressed again or the unit is switched off. The red light on
the button indicates that the unit is in Timer mode
-When there are 500 operating hours left, the On / Off
lamp will start to flash. When the appliance has been in
operation for more than 8000 hours, all 3 red lights start
flashing and an acoustic signal is heard around every 30
minutes. The lamp must now be replaced.
-When the lamp is replaced Reset the Timer by holding
down the Timer button (3) and the Fan button (2) for
more then 5 seconds. 5 quick beeps are heard, and the
unit is ready for use again.
Timer conditions
8h 8h
8h
16h
16h
Timer
start
high
low