User Guide Multi Air Cleaner
English Description MAC500s produces UV-C light under controlled conditions. Different UV-C wavelength has different properties. The MAC500s uses two wavelengths. One is a powerful sterilizer when it is in direct contact with pathogens and the other wavelength uses the available oxygen (O2) to naturally produce a low level of ozone (O3). The low level of ozone recreates the fresh air from outside in nature inside your home or office.
Lifetime of the lamps The lifetime of the JIMCO special lamp is 8,000 operating hours. When the lamp has been used for 8,000 operating hours, the efficiency of the lamp will be reduced, which means if the smell is not reduced as usual then the lamp should be replaced. 8,000 operating hours, equals to approximately a year of operation (21.9 hours per day). If the effect of the device drops before the end of 8,000 operating hours, you should check, if the JIMCO Special lamp is dirty with e.g. dust particles.
Technical Data: UV lamp 1x8 w Operating hours 8000 timer Voltage 120V 50/60Hz Length 310 mm Power consumption 23 w Height 90 mm Room area 60 m3 Width 90mm A: B: 1.1 Fig.1 1.2 Fig.
Lamp change: Step: 1 Step: 2 Disconnect the power to the MAC500 by unplugging (position 2) from the wall socket Step: 3 Remove the four screws (position 3) and remove the cover (position 4) Step: 4 Lift the lamp (position 5) out of lamp clip A (position 6) and lamp clip B (position 7) Step: 5 Pull the lamp (position 5) out of the socket (position 8) Step: 6 Insert the new lamp (position 11) into the socket (position 8) Push the lamp (position 11) down into lamp clip B (position 7) and lamp clip
Questions and Contact Producer: Jimco A/S +45 6251 5456 www.jimco.
