User Manual

M303 | Clone Looper
™
4
USE AN EXPRESSION PEDAL TO CONTROL
LOOP VOLUME
Connect an expression pedal such as the DVP Volume (X)™
Pedal to the M303’s EXP jack with a TRS cable. Use the rocker
to adjust loop volume. This will disable the VOLUME knob.To
reenable the VOLUME knob after disconnecting the expression
pedal, simply twist the VOLUME knob past 12 o’clock twice.
USE A TAP SWITCH TO PLAY LOOP ONCE
Connect an MXR Tap Tempo Switch to the M303’s EXP jack with
a mono cable. To initiate Play Loop Once mode, tap the switch.
The green PLAY/STOP LED will flash until the loop ends. Tapping
the switch at any time during the loop’s duration will re-trigger
the loop, allowing for a stuttering effect.
USE A TAP SWITCH TO CONTROL VOLUME
KNOB’S PUSH FUNCTIONS
Connect an MXR Tap Tempo Switch to the M303’s CTR jack.
You can now use the tap switch to control the speed and
direction of the loop as well as clear the loop quietly.
TRUE BYPASS MODE
The M303 uses buffered bypass switching by default. To enable
true bypass switching, press and hold the VOLUME knob while
powering up the pedal.
Advanced Operation