Use and Care Manual

ORIGINAL
Laboratory:
Phone : [phone]
Regd. Office:
TÜV SÜD Certification and Testing
Fax : [phone]
TÜV SÜD Certification and Testing (China) Co., Ltd.
(China) Co.,Ltd.
www.tuv-sud.cn
Shanghai Branch Testing Center
Shanghai Branch Testing Center
No. 1999 Du Hui Road, Minhang District, Shanghai
Hardgoods Laboratory
201108 P.R. China
Page 9 of 10
Test Report No 70.452.19.12506.01
Dated 2019-11-01
2. EN 16582-3:2015 Domestic swimming pools Part 3: Specific requirements including safety and test methods for
aboveground pools
Clause
Requirement
Result
Verdict
4
Requirements and test methods specific to aboveground swimming pool
General
4.1
For new basin designs and for existing basin constructions that are
structurally modified, the following tests shall be carried out with at least
one test sample.
Complied
P
4.2
Aboveground swimming pool with frame-supporting walls
4.2.1
Resistance to horizontal deformation
Requirements
4.2.1.1
On completion of the test, the swimming pool shall not collapse and shall
meet there requirements set forth in EN 16582-1 clause 4.5.
Self-
stabilizing
pool
N/A
4.2.2
Resistance to vertical deformation
Requirements
4.2.2.1
On completion of the test defined, the entire product shall not suffer any
permanent deformation affecting its structural integrity.
Self-
stabilizing
pool
N/A
4.2.3
Bursting strength
General
4.2.3.1
The bursting strength test is performed after carrying out the resistance
tests for horizontal deformation (4.2.1.2) and vertical deformation (4.2.2.2).
Self-
stabilizing
pool
N/A
Requirements
4.2.3.2
On completion of the test defined in 4.2.3.3, the pool shall not burst and
shall not suffer any permanent deformation affecting the product's
structural integrity.
Self-
stabilizing
pool
N/A
4.3
Aboveground swimming pool with self-stabilizing walls
4.3.1
Capacity to stop an overflow
Requirement
4.3.1.1
On completion of the tests described in 4.3.1.2 (Pool overflow) and 4.3.1.3
(Behavior test of the wall under load), the swimming pool with self-
stabilizing walls shall not collapse or empty suddenly.
Complied
P
Inflatable compartment
4.3.2
The swimming pool with self-stabilizing walls generally comprises an air-
inflatable upper tube. In this case, all of the air inlets provided for inflation
shall be fitted with caps permanently secured on an accessible part of each
inflatable compartment of the swimming pool with self-stabilizing walls.
Once this part is inflated, the caps located inside the swimming pool with
self-stabilizing walls shall be able to be pushed back inside the upper part
so that they do not protrude from the surface by more than 5 mm. The
caps of the inflation ports should not be able to become detached and
should be protected against accidental removal.
Check valves shall be fitted in order to prevent an instantaneous deflation.
Complied
P
4.3.3
Stability in the event of deflation of the upper tube
Requirement
4.3.3.1
On completion of the test, the swimming pool with self-stabilizing walls
shall not collapse.
Complied
P
4.3.4
Bursting strength
Requirement
4.3.4.1
On completion of the test defined in, the swimming pool with self-stabilizing
walls shall not burst and shall not present any permanent deformation
Complied
P