Specifications

CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting condition or different
operational conditions for a stand-alone modular transmitter in a host, host manufacturer have to consult with module
manufacturer for the installation method in end system.
2.4 Limited module procedures
This module is Limited single modular without shielding, host manufacturer have to consult with module manufacturer for the
module limiting conditions when integrate the module in the host. module manufacturer should reviews detailed test data or
host designs prior to giving the host manufacturer approval.
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
The device has been evaluated to meet general RF exposure requirement. The device can be used installed and operated with
minimum distance 0mm between the radiator and your body.
2.7 Antennas
This radio transmitter FCC ID: 2A6LO-CKT02J has been approved by Federal Communications Commission to operate with the
antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Antenna No.
Operate frequency band
Antenna Type
Maximum antenna gain
Bluetooth
2400-2500MHz
PCB Antenna
0dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:2A6LO-CKT02J".
2.9 Information on test modes and additional testing requirements
Host manufacturer which install this modular with single modular approval should perform the test of radiated emission and
spurious emission according to FCC part 15C:15.247 and 15.209 requirement, only if the test result comply with FCC part
15.247 and 15.209 requirement, then the host can be sold legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements
for the system such as Part 15 B.