User's Manual

Arm/Disarm via keypad or keyfob
(1) Arm Away
When the system is under disarm, press “ ” on keypad or keyfob, the status LED turns
from Green into Red with the voice guide “Arm away, close door and window, exit delay”,
with the music. When the exit delay ends, the voice guide will sound “Armed away!”
If during zone alarm, press on keypad, or keyfob, the voice will guide “Disarm before
arm!” If under arm situation, press “ ” on keypad or keyfob, the voice will guide “Armed
away!”
“ ”
-08-
For arm away
For arm stay
For disarm, and also for fire alarm(press for 2s)
For programming, and also for panic alarm(press for 2s)
Figure or navigation key for up turn, for menu operation or query
Figure or navigation key for down turn, for menu operation or query
It means ಯdeleteರwhileinputtingfiguresorquitformenuoperation
Forenter
Front Panel Keypad
(2) Arm Stay
It enables users not to alarm in active zone but alarm in other zones.
If under disarm, press on keypad or keyfob, the status LED turns from Green into
Red, the voice will guide “Arm stay”.
If under arm away, and with no alarm, press on keypad, the voice will guide “Enter
password!” Users can enter arm stay status with code input or direct keyfob operation.
If under zone alarm, press on keypad or keyfob, the voice will guide “Disarm before
arm!”
“ ”
“ ”
“ ”
Users can arm away, arm stay, disarm or emergence via keypad or keyfob. Arm or disarm is
not available during programming or trouble query. Via keypad requires master / user code,
while via keyfob requires no code.
-09-
(3) Disarm
Press on keypad or keyfob, the voice will guide “Enter password, / add 0 to delete the
event log .
Disarm with alarm list cleared:
Input the code( ) ending with “ 0 ”, and “ # ”, the arm LED turns from
Red to Green with the voice guide “Disarmed, alarm log eliminated!”
Disarm with alarm list saved:
Input the code (except installer code) ending with just “ # ”, the arm LED turns from Red to
Green, with voice guide “Disarmed!”
(4) Window/Door open remind
When magnetic contacts are registered with control panel, if the panel don't collect the
close signal from them, and it will cause failure when arm away (arm-stay) the system.
This failure will be indicated with voice Window or door is open, Arm failed.” and SMS
message will send as long as it is selected.
“ ”
”
except installer code
“
Note: If disarm by keyfob, the alarm list will be saved.
a) The interfering will cause the signal failure of wireless signal, then Arm failure. At that situation,
please separate and close the magnetic contacts again to make sure Arm successful. For
security reasons, it is strongly suggested to make sure every arm successful. This can be
audio confirmed by internal siren sound and SMS massage. To set the internal siren, refer to
page 24 “Call Back When Arm/Disarm”.
b) If users want to ignore the open area remind, please refer to page 27 to turn off this function.
Note
If under arm stay, press “ ” on keypad or keyfob, the voice will guide “Arm stay”.
Trigger alarm via keypad
It enables users to trigger alarm via keypad or keyfob in emergency.
Trigger panic alarm:
Arm/Disarm via RFID Tag
Users can only arm away or disarm via RFID Tag.
Arm or disarm is not available during programming or trouble query or Zone alarming.