User's Manual
-06-
Walk Test:
1. Enter Menu.
2.
3. Trigger the desired devices, and the info about them will disappear on the LCD.
4. After all test, press “ ” to exit.
Test GSM signal:
The communication signal strength should be tested to confirm if GSM module work
well.
To test GSM signal:
1. Enter Menu.
2
Step 7: Permanently Installing
In order to optimize wireless communication, consider the following guidelines:
1. Whenever possible, mount the panel centrally in relation to wireless sensors.
2. Avoid installation in close proximity to sources of high nois
e or radio frequency
interference. air conditioner, heater or circuit breaker boxes.
3. Minimize the distance between the panel and transmitters.
4. Minimize the number of obstacles between the panel and transmitters.
5. Metal based construction materials, such as steel reinforced concrete walls, will
reduce the range radio transmissions
Having chosen and tested the mounting location of the control panel and each
transmitter, it is ready to permanently install the panel.
For example,
of
Select “8.Aided Test” ĺ “ # ” ĺ “2.Walk Test”ĺ “ # ”.
Select “8.Aided Test” ĺ “ # ” ĺ “4.GSM Test”ĺ “ # ”.
0-31 means for the signal strength. 31 means the strongest. To make sure normal
communication, pls use over 12.
At first, stick “Installing Hole Drawing” on the location for control panel. Drive 2 screws on the
fixed position , and then hang the control panel directly on the screws. While driving the screws,
pls pay strict attention to the depth of screws to make sure easy hang and tamper switch work
normally. There are one tamper switches: rear tamper. Compress the tamper switch while installing.
If the control panel is removed or opened, tamper will be triggered.
-07-
InstallingGHoleGDrawing
Wall Wall
Figure -6- Figure -7-
Figure -8-
Figure -9-
2: Using System
Disarm
Arm-away
Arm-stay
Panic
While hanging the control panel, please don’t shake the product to avoid breaking the tamper switch
Arm and disarm the system and practice using it. Trigger the alarm by arming the system and
opening protected door/windows and walking past PIRs.