User's Manual

2. Once the correspondent signal is transmit, the detector display will disappear on LCD. If it will
not disappear, it indicates trouble occurs.
-28-
3. When all detectors disappear out of LCD, the voice will guide “Walk test over!” meanwhile
with “No device!” indicating on LCD.
4. Press “ * ” to quit when test is finished.
Transmitter
It includes TX list (all registered TX and status report), and TX test under this menu. TX test is to
test and identify wireless signal. With signal received from registered transmitter, it will display
info of it, including ID. With signal received from unregistered transmitter, it will indicate as
unknown signal.
To Test TX
1. Select “ Transmitter test ”, press “ # ”, The voice will guide “ Transmitter test starts, transmit
wireless signal!”
2. Trigger the transmitter, if it is registered, the info will display on LCD. If it isn't registered, it
will indicate as unknown signal.
3. Press “ * ” to quit after test finish.
GSM Test
To ensure the validity of GSM communication, please test the signal network at the installing
position.
To test GSM signal
From the menu, select “ 8.Aided Test ”ĺ “ # ” ĺ “ GSM test ” ĺ “ # ”.
Send TEST SMS Interval
The control panel could be set to send a message at the needed time of each week for testing. This
testing message will be sent to all the numbers set before.
5: Troubleshooting
For detailed system trouble and solution, please refer to following table:
Table 4: Trouble & Solutions
-29-
“T” will display on LCD if there is. Users can press “ ” to enter the trouble list, and then press
“ ” or “ ” to check. If the trouble is solved, it will disappear out of the list.
Users can clean the display of system trouble remind by disarm the system, but system trouble
information will still be saved in the system trouble list.
If the time is unset, the voice guide of trouble will not sound. System trouble voice indication
will not be available from 10:00PM to 7:00AM. During trouble query, the zone will not alarm
with it trigger.
The system has no
feedback when the
zone is triggered
The zone is bypassed, Un-bypass the zone
When disarm, zone type 1,2,3 do not alarm; arm-stay zone type 2 does not alarm. Operate normally
Different wireless zones use the same code. Delete this wireless zone
change the code learn and try again
No GSM signal
No signal received from mobile phone, SIM card is invalid; Or re-choose a suitable position
for installation
Time Unset
No SIM card
Loose contact of SIM card, Please re-insert the card after re-powering off the panel
Re-set the system time correctly
SMS Trouble
Failure of SMS send, Check if there is no balance for SIM card
Dialling Trouble
1. Refuse or power off of receiving phone, Pick up the phone in time
2. Overdue of the SIM card, Check if there is no balance for SIM card
Commu-
nication
Trouble
Low GSM signal Weak signal of GSM communication, Choose a better position for installation
WL.
Trouble
Low Battery
Transmitter Loss
Low power of transmitters, Change battery
No signal is received during supervision period, Check if the transmitter is moved or broken
Power is cut off, Check the power connection timely
AC failure
Solutions
Low Battery
Check the power connection timely
Trouble
No call for alarm
Set correct voice telephone number, Set more than two voice telephone numbers.
False alarm for
wireless zones
Abnormal work for