User's Manual
-20-
Duress Code
While users disarm with duress code, it will indicate “Disarm” on site but will send
alarm info.
To set duress code: Same as Master code set.
User Code 1~4
The user code enables users to arm or disarm.
To set/delete user code: Same as “Temp. Code Set”.
Note: The default duress code is 0809, which is strongly recommended to edit after installation.
Phone can be personal phone for voice or for SMS. The system will dial the phone or send
SMS when alarm occurs.
Voice phone set
It enables users to edit or delete the number users set before.
To set voice phone
1. Select one telephone group number, press “ #” to set.
2. If any phone is set before, it will display. Press “ # ” to edit. If no phone is set before,
input directly.
3. The phone number can be 16 digits utmost. Press “ # ” to finish. Or if no figure is input,
and “ # ” is pressed directly, the number will be deleted.
4. Phone Set
3. Input the new code, Press “#” to confirm. .
4. The LCD will remind if it is edited or not. Press any key to exit.
5. The LCD will remind if need change the name. Press “#” to confirm. Or “ ” to quit.
With no code input, press “#” to delete it
When users disarm the system with the duress code, the panel doesn’t call the first and second
telephone number. And the panel just call the third and fourth telephone number. So we suggest
that don’t set the third and the fourth telephone number with personal phone number.
Note:
-21-
SMS Phone
Same as voice phone set.
SMS Option
users can select if SMS message will be sent or not for alarm, arm or disarm to save SMS
cost.
To set SMS option:
1. Select the phone group number, press “ # ”to enter.
2. Select parameters users desire to set ending with “ # ”.
3. Select “ ON ” or “ OFF ”.
Panel ID
ID can be set for each control panel so that the Panel can be identified. Different ID must be
set for different control panels, which is 4 digits utmost with default as 1234.
Call Attempts
The Call attempts option determines the number of times the system tries to call a telephone
number before moving on to the next number in sequence. It will not dial again if it exceeds
the attempts. Attempts range can be set 1~30 times.
Ɣ “7” is the factory default.
Ring Attempts
The Ring attempts means the ring times before the phone hangs up. If it is set as “ 0 ”, it
means no remote control by call for the system. It can be set from 1 to 9.
Ɣ “6” is the factory default.
GSM Option
It includes SMS Ack, SMS Confirm and SMS Send. If SMS Ack is turned off, then it is not
available for control panel. If SMS confirm is turned off, then SMS receipt is not available.
If SMS Send is turned off, then SMS Send is not available.
Ɣ On as default.
5. Device Set
For the system to recognize individual devices, each device must be registered. For example, if
the device is a wireless transmitter, registration enables the system to identify the source of a
received transmission. Each device has an individual ID code. Registering the device to the
system familiarizes the system with this code.
WL. Register
There are two ways of register: by code learn or input.
To register by code learn
1. Select the zone number ending with “ # ”. If registered before, it will remind users to re-register.
Press “ # ” to continue, or “ * ” to quit. If not registered before, the voice will remind “Start
enrolling, transmit now!” with counting down for 60s.