User's Manual

Tally Dascom 2600/2610/PRN-7
5.2.5 Selecting the LC display language
This section describes how to make settings in the menu, using the selection of the
national
language as an example.
In this user guide all LC display messages are shown in English language. Your printer
offers also the possibility to show the display messages in German, French, Italian,
Spanish or Turkish language. This example shows how to change from the English
language to the German language. The same procedure applies to the other languages
(French, Italian, Spanish and Turkish).
Select the Setup mode by pressing the Setup key.
S
etup mode and Menu mode may be disabled. Hold
down the Setup key while switching on the printer to
e
nable menu mode. If you want to enable access to
t
his
m
ode permanently, you need to change the
a
ppropriate
s
etting in the menu.
Press the next key (4) several times until the display indicates
Language.
Press the Language key (3).
The display now changes to Parameter mode and
indicates
English in the top line.
The lower line displays Set and Exit. The two arrows < (2)
and > (3) represent the symbols for parameter selection
(“<” indicates descending and “>” ascending). Press the
<
(2) or > (3) key until the desired language is displayed, in
our example German.
Save your selection by pressing the Set key (1). An acoustic
signal verifies this action.
You can exit Parameter mode without saving a setting
by
pressing the Exit key (4), the old setting is retained.
After saving your setting (Set), the display in our example
Ges.Men indicates the following text:
33