User's Manual

Tally Dascom 2600/2610/PRN-7

increment or decrement the TOF value. After adjustment, press Key 1 (Set) to save

the change.

et the Tear position in the same way. Move the perforation of the stationery

xacly to the Tear Edge.

5.1.2 Select a font

Below example demonstrates how to select Roman LQ font type under the Char setting.

1) First, load fanfold paper to one of the tractors and bring the printer Offline. Pressing

ǏLoad/EjectǐandǏSpeedǐkeys simultaneously activates the parameters setting

operation. The printer prints out 2 lines of key assignments valid for the parameter

setting operation.

Key 1 Key 2 Key 3 Key 4

Menu Adjust Char

2) PressǏTearǐ(i.e. Key 4 in the listed assignment) to enter the Character setting. The

printer then lists the below line:

Font CPI

3) “Font” allows selecting desired font type and “CPI” allows setting desired character

pitch.

PressǏLoad/Ejectǐ(i.e. Key 2) to enter the Font submenu. The printer responds with

the

below line:

HS-Draft * Set < > Exit

4) HS-Draft * indicates the current selection. Set means to save the change. < selects the

previous item. > selects the next item. Exit exits the menu. Here, pressǏSpeedǐ(i.e.

Key

3) to show the next font. Keep pressingǏSpeedǐuntil the print shows Roman:

Roman LQ Set < > Exit

5) PressǏOnlineǐto save the change of font type to Roman. The printer sounds the

buzzer and prints the below line to confirm successful change.

Roman LQ * Set < > Exit

Modify the CPI in a similar way if desired (these two are only temporarily

tored).