User's Manual

Tally Dascom 2600/2610/PRN-7

4.2.4 Setup mode

In this mode, the following settings are available:

䕔㻌S

etup key: Sets the printer to setup mode, in which the

following settings can be selected.

䕔㻌M

enu key (1): Other menu settings. Access may be

disabled by menu settings (see note below).

䕔㻌A

djust key (2): Sets the Tear position and first printing

line (TOF). If you have the PullTr (Pull - Tractor) selected

Adjust is not available.

䕔㻌C

har key (4): Sets the font and the number of

characters per inch temporarily.

ccess to the other menu settings (Menu) may be disabled by the

anufacturer.

Proceed as follows to release this lock temporarily.

1) Switch off the printer for approx. 5 seconds.

2) Switch the printer on again keeping the Setup key pressed.

4.2.5 Power on functions

If you keep one of the following keys pressed during power-on until the printer has

completed initialization, the corresponding function is activated:

䕺 If you keep the Online key depressed while turning on the printer, you enter the

printer’s advanced menu mode. The advanced menu mode is described in the section

5.4.2

of this manual.

䕺 If you keep the S

etup key depressed while turning on the printer, you regain access

to the printer menu if you had locked it before with the help of the Menu Lock function.

䕺 If all four f

unction keys (keys 1 to 4) are depressed simultaneously while turning on

the power, all printer settings are reset to the default values, except the

orml (Form

length) setting in advanced menu mode.

䕺 Holding Function key 4 while turning on the printer prints out the parameter settings.