User's Manual

T
ally Dascom 5130P
44
9 Interfaces
Parallel Interface
Parallel Interface Pin Assignment
Pin Signal Name Signal Transmission
1 STROBE,¯¯¯¯¯¯ Printer I Computer
2~9 D A T A Printer I Computer
10 A C K,¯¯¯ Printer J Computer
11 BUS Y Printer J Computer
12 PE Printer J Computer
13 SELECT Printer J Computer
14 AFXT ,¯¯¯¯ Printer I Computer
15 U n used U n used
16 GN D Printer Q Computer
17 F - GN D Printer Q Computer
18 +5V Printer J Computer
19~30 GN D Printer Q Computer
31 IN I T ,¯¯¯¯ Printer I Computer
32 FAULT,¯¯¯¯¯ Printer J Computer
33 GN D Printer Q Computer
34 U n used U n used
35 FUSE Printer J Computer
36 SLCTIN,¯¯¯¯¯¯ Printer I Computer
Parallel Interface Connector Diagram
Note: Any
external devices connected to the parallel port should not draw current exceeding 200 mA from pin
18;
otherwise it may affect the printer operation.
USB Interface
The USB i n te rf ace conforms to the Universal Serial Bus 2.0 Spe c i f ication s. It supports the Full Speed mode at
12 Mbps. It uses the “B” type USB connector.
Serial Interface
RS232C (9-pin Sub-D male Interface)