User's Manual

ally Dascom 5130P

Setup Menu

With the cove

r closed, holding USER1 and USER2 at power-on brings up the Setup Menu. The printer resets

and L1~L2=ON and waits for paper insertion.

All printed dialogs in the Setup Menu are viewed in up-right orientation as in Fig. 2. [NOTE: 1xxx dialog is up

side down when viewed by users.]

Rear of printer

English Deutsch

…

Setup dialog

Fig.2---Setup dialogs in up-right orientation viewed by operators.

Language Selection

(This feature is not supported in all models)

1) List out all languages in native characters and underline the tentative language. Assign USER1=OK and

USER2=Next. Fig. 3 illustrates the operation of language selection.

2) Advance the page for preview and wait for key press. Retract the paper for printing.

3) Each pressing of USER2 repeats 1~2.

4) Once the language is selected, subsequent dialogs are prompted in the selected language.

All subsequent dialogs in selected language.

Aktuelle Konfiguration? [USER1]=OK [USER2]= Weiter

English Deutsch

Рос с ия .. [USER1]=OK [USER2]=Next

English

Deutsch Рос с ия .. [USER1]=OK [USER2]=Next

Dialog starts from this line. Key assignment in native language.

Enable/Skip Listing Current Configurations

The termination of language selection immediately prompts the “Print current configurations?” This allows or

skips the listing of current configurations before going into parameters setting. USER1 prints the listing and

USER2 skips the listing.

Contents of the listing: Current configurations for Menu1 and Menu2.