User's Manual

Tally Dascom DT-210/230 User Guide V1.3
85
The commands listed below in the first column are defined as “obsolete commands” in the ESC/POS
command system.
This printer supports both upward-compatible commands and obsolete commands. However, the
upward-compatible commands are recommended to use.
“Obsolete commands” are commands that are supported by legacy models;
however it is recommended to replace them with upward-compatible commands,
because they will not be supported in the future products.
Obsolete command Upward-compatible command
ESC i Partial cut (one point left uncut) GS V
ESC m
Partial cut (three points left uncut)
GS V
ESC u Transmit peripheral device status GS r
ESC v Transmit paper sensor status GS r
FS p
Print NV bit image
GS ( L <Function 69>
FS q Define NV bit image GS ( L <Function 67>
GS v 0
Print raster bit image
GS ( L <Function 112 + 50>