User's Manual

Tally Dascom DT-210/230 User Guide V1.3
46
Here is the self test status page and its explanation. The printout is an example. It may differ
depending of installed options or interfaces:
3. Press the FEED button while the printer is in the self-test mode.
Then the printer will print a rolling pattern using only the built-in character set.
After printing the following message, the printer is initialized and returned to the normal mode.
Model
Firmware Version
S/N
Interface
Number of data bits
Number of stop bits
Flow Control
Parity Checking
Receive error method
Buffer size
Resident Character Types
Density level
DIP Switch setting
SELF-TEST
Model DT-230
Firmware Version : SV1.02.16
S/N: 000000000000
Serial Interface
Baud Rate : 19200 bps
Data bits : 8 bits
Stop bits : 1 bit
Flow Control : DTR/DSR
Parity Checking : None
Receive error : print ‘?’
Buffer Capacity
48K bytes
Resident Character
Alphanumeric
Simple Chinese
Print Density
LIGHT [ 1 2 3 4 ] DARK
Print Speed : 260mm/s
Paper Width : 80mm
BM sensor : Disable
DIP Switch1
1 2 3 4 5 6 7 8
On
Off * * * * * * * *
DIP Switch1
1 2 3 4 5 6 7 8
On
Off * * * * * * * *
If y ou want to continue SELF-TEST
Printing, please press FEED button!