User's Manual
Table Of Contents
- About This Manual
- 1 PRODUCT OVERVIEW
- 2 SETUP
- 3 INSTALLING DRIVER
- 3 CONNECTING TO COMPUTER
- 4 SETTING/CHECKING MODES
- 5 SETTING DIP SWITCHES
- 6 TROUBLESHOOTING
- 7 SPECIFICATIONS
- 8 CHARACTER CODE PAGES
- 8.1 Common to All Pages (International Character Set: USA)
- 8.2 International Character Sets
- 8.3 [User-defined page]
- 8.4 [PC437: USA, Standard Europe]
- 8.5 [PC850: Multilingual]
- 8.6 [PC852: Latin2]
- 8.7 [PC858: Euro]
- 8.8 [PC860: Portuguese]
- 8.9 [PC863: Canadian-French]
- 8.10 [PC865: Nordic]
- 8.11 [PC866: Cyrillic #2]
- 8.12 [KU42: Thai]
- 8.13 [TIS11: Thai]
- 8.14 [TIS18: Thai]
- 8.15 [PC720: Arabic]
- 8.16 [PC864: Arabic]
- 8.17 [WPC1256: Arabic]
- 9 PRINTING CONTROL COMMAND SETS
Tally Dascom DT-210/230 User Guide V1.3
28
2. The interface is pre-set with the IP address 192.168.0.31. DHCP is disabled. Enter this IP address
in your browser to get access to the built in web page.
Item Explanation
Information General Show the ETH01 information
TCP/IP Show the TCP/IP information
Configuration
Network
TCP/IP Set the TCP/IP information
Reset Reset the ETH01 or return to the factory default
setting
3. Click Configuration→Network→TCP/IP, the default setup for getting IP address is manual, you
can start setting the IP address, subnet mask and default gate way.
Item Explanation
Get IP Address Show the method of setting the IP address
IP Address Show the IP address
Subnet Mask Show the subnet mask of the IP address
Default Gateway Show the default gateway
4. If you want to enable DHCP mode, select “Auto” in Get IP address option.
Or you can do this by pressing the reset button next to the RJ45 socket while you switch on your
printer.
Verify the new setting by pressing the button after some seconds again. The new IP address is
being printed.