User's Manual

3 Control Panel Operation
3.1 Keys and LEDs
There are 4 keys on the Control Panel, from right to left:【Online】key、【Line skip】key、
【Top-of-form】 key and【Load/Eject】key. Meanwhile, there are 4 LEDs, from right to left:
〖Online〗LED、〖NLQ〗LED、〖Front out〗LED、〖Power/Paper out〗LED, The Control Panel
is shown as below:
Instruction for each key and each LED:
 LED
1、〖Power/Paper out〗：On: paper loaded; Flashing: Paper out; On or Flashing: Power on;
2、〖Online〗: On: on line; Off: Off line;
3、〖NLQ〗：On: NLQ; Off: LQ; Flashing: Ultra high speed.
4、〖Front out〗：On: after printing, single sheet paper exits at the front; Off: after printing,
single sheet paper
exits at the rear.
 Keys
1、【Online】Key
The printer can be set online or offline by this key.
When the printer is at online status, press this key one time to switch the printer to offline
status, And this Online LED is off. Press this key again to switch the printer to online status.
And this Online LED is on.
When the paper is not loaded or paper out, and the printer is offline. Power LED is flashing;
After the paper is loaded, the printer will be reset to online status, Power LED is on. The
printer is available. If the paper is at tear-off position, press this key to eject the paper to
starting print position.
2、【Line skip】Key
When the print is at Online/Offline status, paper will be fed one line forward when press this
key one time. If continuous form is used, by holding down this key, the printer will initially
feed a few lines and then perform a form feed. If the paper is at tear-off position, press this
key to eject the paper to starting print position.
3、【
Top-of-form】Key
Holding down this key, the printer will start to feed the paper backward at Micro Feed
mode.
Paper feed will be stopped when release this key.
4、【Load/Eject】Key
When press this key, the printer will act differently based on different paper.
When the paper is loaded (Online/Offline)