User's Manual

2.2 Install the Sheet Feeder
As shown in the picture below, ensure the sheet feeder fingers fit into the slots in front of the
printer. Push in the sheet feeder until its sides latch on the fixed bolts in the printer. The sheet
feeder is now installed successfully.
To remove the sheet feeder, use one hand to hold the printer and the other hand to pull and
unlatch the sheet feeder.
2.3 Connecting the Interface Cable
The 36-pin Centronics parallel and USB ports are located at the rear of the printer.
IMPORTANT: Make sure the printer and the computer are switched off before connecting or
disconnecting the interface cable to prevent electrical damage to the interface ports.