User's Manual

Tally Dascom 1140
Paper Setup Valid Settings Function
Tear
Auto, Manual, View,
Auto @ FF
Auto: No incoming print data in 1~2 seconds after
printing completed, the printer advances the form to
the tear-off position. When the printer receives new
print data, the form is ejected to the top-of-form.
Manual: After the completion of a print job, press a
panel key to advance the paper to the tear-off
position.
View: No incoming print data in 1~2 seconds after
printing completed causes the printer to advance the
paper by 2 lines. Printing resumes 2 lines below the
torn edge.
Auto @FF: a formfeed command is necessary to auto
feed the form to tear position.
Buzzer No, Yes
No: Buzzer does not sound if out of paper.
Yes: Buzzer sounds if out of paper.
BlackMark No, Yes
No: Disables black mark sensor.
Yes: Enables black mark sensor.
When “Yes” and online, pressing the Load/Eject key
advances the paper to the tear-off position.
BlackMark commands: (also see section 5.6)
• 1D 0C:
Feeds paper to the print position designated by the
black mark. Advance the paper to the tear-off
position after printing.
• 1C 28 4C 03 00 42 m:
m = 0: feeds paper to the print position designated
by the black mark.
m = 1: feeds paper to the black mark tear-off
position.
Pressure lever
Invalid,Standard,
Speed
The pressure lever presses the paper against the
print platen during printing, but it is released for paper
loading.
Invalid: If you uninstall the lever or want to disable the
function, set this setting to “invalid”.
Standard: Release the lever for paper loading and
lower the lever to press the paper against the platen
during printing.
Speed: When the paper is in tear-
off position, after the
printer received printing data, the printer will judge
whether tear-off was implemented first. If tear-off was
implemented and printing position is in lever area,
then the printer will press the lever; If tear-off was not
implemented, the printer will not press the lever.
21