User's Manual

Table Of Contents

Tally Dascom 1140

4.4 Online State

Function

Name

Switch

Operation

LED Function Description

Tear Off {S1}

L2, L3 flash

This is valid for tractor mode only. It feeds the form

to the tear-off position. After tearing off the form,

printing starts on the next TOF by pressing any key

or receiving print data from the host.

LF {S2}

Feeds one line with every press of S2

FF [S2]

Pressing this key will feed paper one line forward.

By holding down this key, the printer will initially feed

a few lines, then perform a form feed (continuous

paper mode) or eject the form (single sheet mode).

Load/Eject {S3}

● Load: Automatically loads the paper (according to

path selection) when no paper is on the platen.

●

Eject: For rear tractor, it retracts the form from the

platen to allow users to install cut sheets. (NOTE:

Users have to toggle the path

selection lever.) For

cut sheets, it ejects the form on the platen.

Online {S4}

Toggles between Online and Offline states.

Setup State [S4]

Hold the S4 key for 3 seconds. Toggles to 3s Setup

state. Indicated by flashing L4.

Clear Buffer

and Reset

[S4]+{S1}

● Clears the print buffer. Beeps once upon

completion.

● Pressing S1 longer initializes the printer to

default settings.Beeps 3 times upon completion.