User's Manual

Tally Dascom 1140
3.2 Friction Feed Handling
1. Raise the single sheet feeder until it locks into its mounting.
2. Move the paper-feed lever forward to “ ” for friction feed mode.
3. Adjust the print gap lever if necessary.
4. Align the left paper guide with the mark on the left of the single sheet feeder.
5. Adjust the right paper guide to the width of the paper used.
6. Insert a sheet of paper. Make sure that the bottom edge of the paper engages snugly with
the platen.
7. The paper should advance automatically to the print position. The printer is now ready to
print in the online state.
3.3 Tractor Feed Handling
1. Move the paper-feed lever backward to “ ” for continuous paper position.
2. Adjust the print gap lever if necessary.
3. Raise the tractor doors and fit the first 3 paper holes onto the left tractor pins. Close the
left tractor door. In the same way, install the paper on the right tractor.
4. Adjust the right tractor to the width of the paper until the paper is flat. Do not stretch the
paper too taut. Push the right lock lever down to secure the right tractor in place.
5. Press the【Load/Eject】key to load the paper to the starting print position. The printer is
now ready to print in the online state.
11