User's Manual

Tally Dascom 1125
36
Adjust Physical Margins
Adjust Page Margins allows for adjustments of physical left, top margins and tear-off position. Warning: Once
these settings are changed, resetting the printer to factory defaults will not initialize these settings back to
the original settings; so it is not advisable to perform this adjustment unless it is absolutely necessary.
Adjust Top Margin Procedure:
1. Enter the Adjust Page Margins function by holding down the
ɋ
Load/Eject
Ɍ
and
ɋ
Online
Ɍ
keys while
powering up until the printer beeps twice.
2. Load paper.
3. The printer will print as below:
Adjust Page Margins:
ɋ
LF/FF
Ɍ
=OK
ɋ
Tear/Off
Ɍ
= Back
ɋ
Load/Eject
Ɍ
= Next
ɋ
Online
Ɍ
= Exit
Current Setting: Adjust Fanfold Top Margin
PressǏLF/FFǐkey to confirm selection if the paper used is fanfold type. The printer will print as
follows:
Procedure
˖
Install fanfold paper to tractors
Ǐ
LF/FF
ǐ
= Add
Ǐ
Load/Eject
ǐ
= Reduce
Ǐ
Online
ǐ
= Exit
Each step is 0.5 mm
Function of keys:
Ǐ
Te a r O ff
ǐ
key: Decrease 0.5mm
Ǐ
Load/Eject
ǐ
key: Increase 0.5mm
4. Press ǏLF/FFǐ key, printer will print “Save settings
˛
Ye s ”. Press ǏLoad/Ejectǐ key to choose Yes
or Noˈthen press ǏLF/FFǐ key to confirm selection and exit “Adjust Page Margins” mode by
pressing ǏOnlineǐ. The print head moves to the left side and the printer beeps twice, then the print
head moves to the middle position.
Adjust Left Margin Procedure:
1. Enter the Adjust Page Margins function by holding down the
ɋ
Load/Eject
Ɍ
and
ɋ
Online
Ɍ
keys while
powering up until the printer beeps twice.
2. Load paper.
3. The printer will print as below:
Adjust Page Margins:
ɋ
LF/FF
Ɍ
=OK
ɋ
Tear/Off
Ɍ
= Back
ɋ
Load/Eject
Ɍ
= Next
ɋ
Online
Ɍ
= Exit
Current Setting: Adjust Fanfold Top Margin
4. Press
Ǐ
Load/Eject
ǐ
key until the current setting is “Adjust Fanfold Left Margin”. PressǏLF/FFǐkey to
confirm selection if the paper used is fanfold type. The printer will print as follows:
Adjust Fanfold Left Margin 0