Operator's Manual

22 www.printek.com
You must set each of these values before selecting Upload Logo or the default values will be associated with
your image.
Current Logo Mapping
Once uploaded into the printer memory, your image and settings will be displayed here.
Logo upload procedure: 1. Choose logo file, 2. Set the width, 3. choose the index. 4. Upload it
Delete logo procedure: 1. Choose logo 2. Delete it.
G. Update Printer Firmware, Upload Files to Printer Memory
Procedure:
1. Enter the config page
2. Click Updates.
3. Choose Upload Firmware, choose file and click Upload.
4. After uploading .tgz or .sw file, printer will restart itself. After uploading .fw file, the three LEDs will flash.
Users should restart the printer.
Notice: If fail to upload firmware, which shows as alarm LED flash, power and charge LED off after printer on,
users could upload the firmware again because the printer enters into configuration mode after charging for 30
seconds.