User's Manual

6
www.printek.com|P:888.211.3400|F:269.222.1229|E:[e-mail]
C. Battery Installation
Disposal
Pleasedisposethebatteriesseparatelyandfreeofcostatyoursalesagencyorthedesignatedlocalcollecting
points.
Thereforepleaseconsiderthenationalrecyclingstandards!
DisassemblyandremovalofthebatteriesaredescribedintheUserGuide.
D. Charge Battery
Uncover the printer ports and plug in your AC power adapter to the Power port (must be a Dascom-
supplied accessory). The yellow LED will show solid ON while the printer battery is charging.
NOTE: Charge via USB is not supported, please do not charge via the USB-C port.
E. Power On
Depress the Power button on the control panel. The green LED and the red LED will both be lit while
the printer is going through its startup sequence (about 20 seconds). The red LED will go off, leaving
the green LED on to indicate the printer is ready to print.
When battery volume goes below 5%, the printer will shut down itself. When it’s below 10%, it will
flash yello LED as an alarm of low battery.
Pressbuttontoseebatterychargelevel.
4LED100%charge
3LED75%
2LED50%
Removethetwoscrewandremovethe
battery.