User's Guide

Tally Dascom DL-830 User Guide V1.0
54
6.4 Serial
The serial interface of this printer is compatible with RS-232, using DB25 hole type socket.
Pin
Signal Name
PIN1
GROUND
PIN2
TXD
PIN 3
RXD
PIN 4
RTS
PIN 5
EMPTY
PIN 6
DSR
PIN 7
SIGNAL GROUND
PIN 8~19
EMPTY
PIN 20
DTR
PIN 21~25
EMPTY
The settings of serial interface can be checked by printing self-test page.
The default baud rate
is 38400bps, 8 data bit, no parity, and 1 stop bit. Handshaking protocol is DTR/DSR.
Serial interface connector
6.5 Wifi
Function description:
Network type – User to select.
STA- IP address will be obtained from the terminal network.
AP- IP address will be obtained from the printer, which is acted as WIFI access point.
Channel number – User defined. It can be selected according to the channel number of the
router.
DHCP – User defined. IP address can be obtained dynamically.
Security mode – User defined. User can select the security mode according to WIFI mode and
router encryption type.
Network name – User defined.
IP Address – User defined. If Static Address Method is selected, type in the address the printer will
use on the network.
SubNetMask – User defined. If Static Address Method is selected, type in the subnet mark of the
network.