User's Manual
Table Of Contents
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- CHAPTER 3 NORMAL MODE AND USER MODE
- 3.1 Normal Mode
- 3.2 User Mode
- 3.3 The major menus
- 3.3.1 Sub-menus for Printer Info
- 3.3.2 Sub-menus for Head Info
- 3.3.3 Sub-menus for Version Info
- 3.3.4 Sub-menus for Printer Setup
- 3.3.5 Sub-menus for card setup
- 3.3.6 Sub-menus for Ribbon/Film Setup
- 3.3.7 Sub-menus for Image Setup
- 3.3.8 Sub-menus for Interface Setup
- 3.3.9 Sub-menus for Cleaning
- 3.3.10 Sub-menus for Option
- 3.3.11 Sub-menus for Reset User Default
- CHATPER 4 CLEANING
- CHATPER 5 TROUBLESHOOTING
- CHAPTER 6 SPECIFICATION
- Appendix I: OPTIONS
- Appendix II: FCC STATEMENT
- Appendix III: DASCOM REPRESENTATIVES
Dascom DC-7600 User Guide V1.0
Faults Probable Cause Corrective Actions
Defective Spots
Dirty Card Surface
• Check that card surfaces are clean and dust
free.
• Use new, clean cards.
Cleaning Roller
• Clean the transport rollers
White Line
Ribbon not properly
installed
Check the proper installation of the ribbon
and retransfer film.
Check if ribbon/retransfer film are folded up.
Dirty or defective print
head
Please contact local reseller.
Vague or Light Image
Improper
ribbon/retransfer
film installation
Check the proper installation of the ribbon
and retransfer film.
Check if ribbon/retransfer film are folded up.
Ribbon not
synchronized
Open and close the front cover to
synchronize the ribbon.
Dirty printer or
cleaning rollers
Clean printer
Non-genuine cards
Check if your cards meet specifications.
Recommend that you purchase cards from
Dascom authorized reseller.
If the problem persists, please contact
your Dascom reseller.
Bent Cards
Substandard retransfer
process.
Set decurl time. Correct card curl from Section
5.3.1.
Print peels off
Substandard retransfer
process.
Make sure ribbon and film are installed
correctly. And set the retransfer parameters.
Blank Cards
Improper ribbon
installation
Check that print ribbon and retransfer
film are installed properly.
80