User's Manual
Table Of Contents
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- CHAPTER 3 NORMAL MODE AND USER MODE
- 3.1 Normal Mode
- 3.2 User Mode
- 3.3 The major menus
- 3.3.1 Sub-menus for Printer Info
- 3.3.2 Sub-menus for Head Info
- 3.3.3 Sub-menus for Version Info
- 3.3.4 Sub-menus for Printer Setup
- 3.3.5 Sub-menus for card setup
- 3.3.6 Sub-menus for Ribbon/Film Setup
- 3.3.7 Sub-menus for Image Setup
- 3.3.8 Sub-menus for Interface Setup
- 3.3.9 Sub-menus for Cleaning
- 3.3.10 Sub-menus for Option
- 3.3.11 Sub-menus for Reset User Default
- CHATPER 4 CLEANING
- CHATPER 5 TROUBLESHOOTING
- CHAPTER 6 SPECIFICATION
- Appendix I: OPTIONS
- Appendix II: FCC STATEMENT
- Appendix III: DASCOM REPRESENTATIVES
Dascom DC-7600 User Guide V1.0
initialization.
Film Jam
Probable Cause: Retransfer film winding problem.
Action: Do not turn off power. Refer to Section 2.3 to reload the retransfer
film. Press SET Key to clear this warning and the printer will resume previous
printing after initialization.
Ribbon Jam
Probable Cause: Ribbon winding problem.
Action: Do not turn off power. Refer to Section 2.2 to reload the ribbon. Press
SET Key
to clear this warning and the printer will resume previous printing
after initialization.
Feeder Card
Jam
Pressing SET as LCD display shown may eject jammed card after initialization.
If the fault is not cleared after initialization, turn the rollers manually to clear
jammed card
Flip Card Jam
Pressing SET as LCD display shown may eject jammed card after initialization.
76