User's Manual
Table Of Contents
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- CHAPTER 3 NORMAL MODE AND USER MODE
- 3.1 Normal Mode
- 3.2 User Mode
- 3.3 The major menus
- 3.3.1 Sub-menus for Printer Info
- 3.3.2 Sub-menus for Head Info
- 3.3.3 Sub-menus for Version Info
- 3.3.4 Sub-menus for Printer Setup
- 3.3.5 Sub-menus for card setup
- 3.3.6 Sub-menus for Ribbon/Film Setup
- 3.3.7 Sub-menus for Image Setup
- 3.3.8 Sub-menus for Interface Setup
- 3.3.9 Sub-menus for Cleaning
- 3.3.10 Sub-menus for Option
- 3.3.11 Sub-menus for Reset User Default
- CHATPER 4 CLEANING
- CHATPER 5 TROUBLESHOOTING
- CHAPTER 6 SPECIFICATION
- Appendix I: OPTIONS
- Appendix II: FCC STATEMENT
- Appendix III: DASCOM REPRESENTATIVES
Dascom DC-7600 User Guide V1.0
As shown in the right diagram,
push in the retransfer film
cartridge to the far end until a
“click” is heard to indicate
correct insertion.
Avoid the film touching the printer compartment during
insertion.
Improper retransfer film
installation affects the overall
print quality. After inserting
the retransfer film cartridge,
double-check so that there is
no slanted film:
Open the printer top cover.
Take out the card cassette.
Confirm the retransfer film
stays within the area shown in
the right diagram. (Between
the two stages of guiding
spool 5)If not, re-install
retransfer film cartridge by
following above directions.
35