User's Manual
Table Of Contents
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- CHAPTER 3 NORMAL MODE AND USER MODE
- 3.1 Normal Mode
- 3.2 User Mode
- 3.3 The major menus
- 3.3.1 Sub-menus for Printer Info
- 3.3.2 Sub-menus for Head Info
- 3.3.3 Sub-menus for Version Info
- 3.3.4 Sub-menus for Printer Setup
- 3.3.5 Sub-menus for card setup
- 3.3.6 Sub-menus for Ribbon/Film Setup
- 3.3.7 Sub-menus for Image Setup
- 3.3.8 Sub-menus for Interface Setup
- 3.3.9 Sub-menus for Cleaning
- 3.3.10 Sub-menus for Option
- 3.3.11 Sub-menus for Reset User Default
- CHATPER 4 CLEANING
- CHATPER 5 TROUBLESHOOTING
- CHAPTER 6 SPECIFICATION
- Appendix I: OPTIONS
- Appendix II: FCC STATEMENT
- Appendix III: DASCOM REPRESENTATIVES
Dascom DC-7600 User Guide V1.0
• Direct touching contaminates the ribbon/retransfer film and causes
uneven print quality.
• Avoid excessive impact on the ribbon/retransfer film when replacing them.
• Using non-genuine products may cause poor print quality and printer
malfunction.
• Quality and reliability of the non-genuine products are not guaranteed.
• Even within the warranty period, fees may be charged on servicing the
printer using non-genuine products.
You can get the unused quantity of ribbon and retransfer film.
Refer Section 3.3 to get the unused amount of your ribbon/retransfer film.
LCD Panel operation or the Windows software driver provide an estimation of the remaining
ribbon/retransfer film that are sufficient for your current print job. The LCD displays the [RIBBON
END] or [FILM END] warnings when they close to running out.
Consume the ribbon/retransfer film as soon as possible after purchase.
28