User's Manual
Table Of Contents
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- CHAPTER 3 NORMAL MODE AND USER MODE
- 3.1 Normal Mode
- 3.2 User Mode
- 3.3 The major menus
- 3.3.1 Sub-menus for Printer Info
- 3.3.2 Sub-menus for Head Info
- 3.3.3 Sub-menus for Version Info
- 3.3.4 Sub-menus for Printer Setup
- 3.3.5 Sub-menus for card setup
- 3.3.6 Sub-menus for Ribbon/Film Setup
- 3.3.7 Sub-menus for Image Setup
- 3.3.8 Sub-menus for Interface Setup
- 3.3.9 Sub-menus for Cleaning
- 3.3.10 Sub-menus for Option
- 3.3.11 Sub-menus for Reset User Default
- CHATPER 4 CLEANING
- CHATPER 5 TROUBLESHOOTING
- CHAPTER 6 SPECIFICATION
- Appendix I: OPTIONS
- Appendix II: FCC STATEMENT
- Appendix III: DASCOM REPRESENTATIVES
Dascom DC-7600 User Guide V1.0
1.2 Operating the Printer Safely
The following precautions must be observed to assure safe operation of your printer. Do
not do anything that is not described in this manual. Doing so could cause an unexpected
failure. The manufacturer is not responsible for any problems caused by incorrect
operation of the printer.
Installation
location
Do not install the printer in a damp or dusty location.
Do not install the printer near flammable or explosive materials or a heater,
stove or any other device that produces heat. Do not place the printer near
volatile combustible materials such as combustible materials.
Place the printer away from walls, as shown in the diagram below, to maintain
air flow. Also, maintain at
least 30 cm (12 inches) of open space above the
printer.
Blocking vents may cause the printer to overheat and fail prematurely.
Do not install printer on an unstable table, on a slant, or any place where
there is excessive vibration.
Do not install the printer in a location susceptible to rapid fluctuations in
temperature.
Do not install the printer in a location exposed to direct sunlight.
4