User's Manual

DC-3300 User Manual v1.0
41
CHAPTER3NORMALMODEANDUSERMODE
YoucanchangebetweenNormalandUserModeswhentheprinterisoperating.

Thissectionoutlinesthedifferencesbetweenthesetwomodesandhowtoswitchfromonetothe
other.
3.1NormalMode
Normalmode:Afterstartup,theprintergoesintoNormalModeinwhichtheprintercanprintcards.
Inthismode,afteryoupressthe▲Keyfor1second,theLCDdisplaystheunusedribbonindicated
byaseriesof“*”marks.Each“*”represents20%remaining:
Ribbon Empty[*****]Full

Inthismode,afteryoupressthe▼Keyfor1second,theLCDdisplaysthetemperatureoftheheater
unitandprinthead:
HeaterTemp： 43℃
PrintheadTemp： 38℃

NormalModeMessageList:
Initialize Theprinterundergoessystemdiagnostic
andinitialization. Cards remaining inprinter
fromapr eviousirregularsessionwillbeejected.
Ready The printer is awaiting host requests or
commands.
Printing Theprinterisinaprintingsession.
PowerSaveMode Theprinterisinanenergysavingstate.
 3.2UserMode

 UserModeallowschangingtheparametersandcheckingthestatus.

 StepstochangefromNormalModetoUserMode:
1) AfterLCDdisplays[READY],pressMenu/Exit Keyfor1secondthenreleaseit.TheLCD
changesitsdisplayto[PrinterInfo.],whichistheentrymenuinUserMode:

Ready
Menu/Exit
Printer Info.
Setu
p
: