User's Manual

DC-3300 User Manual v1.0
25
2.1.3 Adjustingthecardinletaccordingtothethicknessofthecards
The factory default supports 0.76mm (30mil) card thickness. Confirm the correct thickness setting
before installing new cards to the  card cassette. The printer configures with 0.25mm(10mil)~
0.76mm(30mil)and0.76mm(30mil)~1.25mm(50mil),2levels.Setthelevertothecorrectposition.
















2.1.4 ManagingRejectedCards

Usingduplexoption,thisprinterisequippedwithfrontandrearslotstoseparatecorrectlyprinted
cardsfromrejectedones.Bydefault,rejectedcardsareejectedfromtherearslot.However,thetwo
slotsareinterchangeableforyourpreference.

FollowthebelowprocedurestoassignthelocationoftheRejectSlot:
 ReferSection3.2tochangefromNormalModetoUserMode.
 Pressthe Key▼ until[CardSetup]isdisplayed.PresstheSETKey.
 Pressthe▼/ ▲ Keyuntil[Stdcardexit]/[Errorcardexit]isdisplayed.PresstheSETKey.
 Pressthe▼/ ▲ Keytoselecttheproperrejectslot.PresstheSETKey.


Byfactorydefaults,theprinteroutputscorrectlyprintedcardsandrejectedones
to the front and rear slots, respectively. If configured with duplex option, the
rejectedcardsareejectedfromrearslotbydefault,whilewithoutduplexoption,
therejectedcardsareejectedfromfrontslotbydefault.