User's Manual
Table Of Contents
- Chapter 1 Introduction
- CHAPTER 2 INSTALLATION
- CHAPTER 3 NORMAL MODE AND USER MODE
- 3.1 Normal Mode
- 3.2 User Mode
- 3.3 The major menus
- 3.3.1Sub-menus for Printer Info
- 3.3.2Sub-menus for Head Info
- 3.3.3Sub-menus for Version Info
- 3.3.4Sub-menus for Printer Setup
- 3.3.5Sub-menus for card setup
- 3.3.6Sub-menus for Ribbon Setup
- 3.3.7Sub-menus for Image Setup
- 3.3.8Sub-menus for Interface Setup
- 3.3.9Sub-menus for Cleaning
- 3.3.10Sub-menus for Option
- 3.3.11Sub-menus for Reset Default
- CHATPER 4 CLEANING
- CHATPER 5 TROUBLESHOOTING
- CHAPTER 6 SPECIFICATION
- Appendix I FCC STATEMENT
- Appendix II DASCOM REPRESENTATIVES
DC-2300 User Manual v1.0
37
CHAPTER 3 NORMAL MODE AND USER MODE
You can change between Normal and User Modes when the printer is operating.
This section outlines the differences between these two modes and how to switch from one to the
other.
3.1 Normal Mode
Normal mode: After start up, the printer goes into Normal Mode in which the printer can print cards.
In this mode, after you press the ▲Key for 1 second, the OLED displays the unused ribbon
indicated by a series of “*”marks. Each “*”represents 20% remaining:
Ribbon Empty[*****]Full
In this mode, after you press the ▼Key for 1 second, the OLED displays the temperature of the
heater unit and print head:
TPH Temp
：
43℃
Env Temp
：
38℃
Normal Mode Message List:
Initialize
The printer undergoes system diagnostic and
initialization.Cards remaining in printer from a previous
irregular session will be ejected.
Ready
The printer is awaiting host requests or commands.
Printing
The printer is in a printing session.
Power Save Mode
The printer is in an energy saving state.