Operation Manual

INSTALLATION
43
ENGLISH
WIRING LAYOUT
Note on ISO-A Connector: Some car manufacturers swap connection A7 and A4. The pin
layout displayed here is the most commonly used. Please refer to your car manual for correct
connection of the ISO connector in your car.
ISO connector A:
A2: Telephone mute. Connect to the handsfree unit of your mobile phone.
A4 YELLOW (B+). Always 12Vdc, direct to battery.
A5 BLUE To system control terminal of an external amplifier or Automatic Antenna (max.
300mA / 12Vdc).
A7 RED ACC (+). Connect to the 12Vdc controlled by the ignition key / switch.
A8 GND. ( - / Ground) Connect to
clean, exposed and unpainted
metal parts of the car chassis
to make a good ground
connection.
ISO connector B:
FRONT SPEAKER
B3 Right + (Gray)
B4 Right – (Gray/Black)
B5 Left + (White)
B6 Left – (White/Black)
REAR SPEAKER
B1 Right + (Violet)
B2 Right – (Violet/Black)
B7 Left + (Green)
B8 Left – (Green/Black)
Additional lines
1) Line OUTPUT Front (Brown)
2) Line OUTPUT Rear (Gray)
3) Subwoofer OUTPUT (Blue)
4) AV Input
5) DVD Output (only in the DUAL ZONE MODE,DVD AV OUTPUT)
6) Driver Safety wire, MUST be connected to the car’s parking break switch-wire. The supplier
waves any and all liability when this wire is NOT connected as directed. Driver can only watch a
movie when the parking brake is ON.